Liquid R News

Defcon vs XPEL PPF: How the Two Films Compare in Australia

Defcon vs XPEL PPF: the short answer

Defcon Glanz and XPEL Ultimate Plus are both clear, self-healing paint protection film with a 10-year warranty, and on thickness they sit within a few microns of each other. The gap is in what each brand puts in writing. Defcon publishes its construction figures and an Australian lab report on UV, and its warranty follows the car to the next owner. XPEL has the larger installer network and the longer warranty on colour film.

Liquid R fits Defcon and STEK film at our Mitcham workshop. We do not fit XPEL, so this is a comparison of what both brands publish, checked in November 2026, and not a workshop test of the two side by side.

Thickness and construction

Defcon Glanz is an aliphatic TPU film with a total thickness of 190 microns, plus or minus 10%, which is about 7.5 mils. The figure is on the Defcon Glanz product page, along with a single-point puncture resistance of almost 10 kg.

XPEL states 8 mil, roughly 203 microns, for its colour film on the XPEL Australia colour PPF page, and installers commonly quote the same number for Ultimate Plus. Thirteen microns is inside Defcon’s stated tolerance, so thickness alone will not separate these two. What Defcon adds is a puncture figure you can hold an installer to.

Self-healing: how deep a scratch recovers

Both films heal light swirls and wash marks with heat from the sun or warm water. Defcon goes a step further and publishes the depth of the healing layer: the top coat is about 13 microns thick. A scratch that stays inside that layer closes up. One that cuts through it is permanent, and that panel of film gets replaced.

That number is useful when you are deciding whether a mark is worth a warranty conversation. XPEL describes the same behaviour on its Australian site, without a depth on the pages we checked.

UV and yellowing: who has tested what

Yellowing matters most on white cars, where any yellow cast in the film shows. Defcon had Glanz tested by ARPANSA, the federal radiation protection agency, in Melbourne in September 2025. Eight specimens were measured, and the report recorded 99.0% of ultraviolet radiation blocked with a protection factor of 95, rated 50+. Defcon shows the report and its reference number on the Glanz page linked above.

XPEL covers yellowing under its warranty, which counts for something. We could not find an equivalent Australian lab report on its local site. If UV matters to you, ask any installer for the test behind the claim, whichever brand they fit.

Warranty: length, transfer and registration

On clear film the headline is the same: 10 years. The detail is where they differ.

  • Defcon: Glanz gloss and Frozen satin carry a 10-year limited warranty, and the coming Defcon ONE is listed at 12 years. The Defcon warranty terms say cover passes to later owners of the car while a valid e-Warranty record exists, and they name abnormal or premature yellowing as a manufacturing defect.
  • XPEL: Ultimate Plus and Stealth are warranted for 10 years from installation against yellowing, cracking, blistering and delaminating, according to the XPEL Australia warranty page. That page lists separate terms for each film. Some transfer to a new owner with proof of the install date, and at least one is marked non-transferable, so read the terms for the exact film on your quote.

Both warranties cover the film and not the paint under it, and neither pays for a stone that goes through the film. That is normal for PPF.

Every Defcon roll is serialised, and each job is logged in the Defcon e-Warranty system by an authorised installer. For an owner, that record is proof the film on the car is the film on the invoice. XPEL warranty work can be done at any XPEL certified installer, which helps if you move interstate.

Satin and matte finishes

Each brand has a satin film: Defcon Frozen and XPEL Stealth. Both turn gloss paint satin, and both protect factory matte paint that cannot be polished. Defcon Frozen uses the same 190 micron aliphatic TPU build as Glanz and carries the same 10-year warranty, so choosing satin does not cost you thickness or cover.

Colour PPF: range against warranty length

This is the one area where the two brands trade places. Defcon Spectra comes in more than 200 colours across gloss and satin, with a 7-year limited warranty. XPEL’s colour film has a 10-year warranty and comes in gloss, satin and metallic finishes. Its Australian page does not give a colour count, so ask a dealer to show you the swatch book.

XPEL’s extra three years is a fair point in its favour. If you are chasing a specific shade, a range of more than 200 gives you a much better chance of finding it. Our colour changes at Liquid R are done in Spectra, from $6980 for a full car.

Local supply and support

XPEL is a listed company based in San Antonio, Texas, and its warranty document names a Texas address. Defcon Films Australia supplies and supports its film from within Australia and says each line is selected for Australian conditions. For a workshop, that means a question about a roll or a claim is answered in our own time zone.

Which one should you choose?

Both are proper films. If the installer you trust fits XPEL, you are not making a mistake. The case for Defcon is that its numbers are published, its UV result was tested in Melbourne and its warranty stays with the car when it is sold. A customer can check each of those without taking our word for it.

The installer matters as much as the roll. Edges, seams and prep decide how any film looks in year five. At Liquid R, paint protection film starts at $180 for headlights, a full front is from $1980, and every painted panel is from $5980, quoted as a fixed price before you book.

Questions owners ask

Is Defcon PPF as good as XPEL?

On published figures, yes. Glanz is 190 microns against XPEL’s stated 8 mil, both self-heal with heat, and both carry 10 years on clear film. Defcon also publishes an ARPANSA UV test and a transferable warranty.

Does Liquid R install XPEL?

No. We fit Defcon Films Australia and STEK paint protection film in Mitcham. If you specifically want XPEL, the brand lists its certified installers on its own site.

Which film is thicker, Defcon or XPEL?

XPEL states 8 mil, about 203 microns. Defcon Glanz is 190 microns plus or minus 10%. The difference sits inside the tolerance, so you would not see or feel it on the car.

Does the PPF warranty transfer when I sell the car?

Defcon’s does, as long as the job was registered in e-Warranty. XPEL’s terms vary by film, so check the document for the product named on your invoice.

Can I get a colour change in PPF from either brand?

Yes. Defcon Spectra offers more than 200 colours with a 7-year warranty, and XPEL’s colour film carries 10 years. Both are thicker than vinyl and self-heal.

Related Guides

Green colour PPF on a black car

Contact Us

Get in touch with us or stop on by to say hey

Give us a call or drop by anytime:
P: 1800 985 880
E: info@liquidr.com.au
A: 12/23A Cook Road Mitcham VIC 3132

Opening hours:
Monday to Friday 8:30am-5:00pm
Saturday 8:30am-12:30pm

Enquiry & Booking